Metra Electronics HYBL-02 Instrucciones De Instalación página 2

connectIons on tHe Interface
from the 1st 24-pin harness:
• Connect the Yellow wire to the 12-volt constant/battery wire of the aftermarket radio.
• Connect the Black wire to the ground wire of the aftermarket radio.
• Connect the Blue wire to the power antenna wire of the aftermarket radio.
If the aftermarket radio does not have a power antenna wire tape off the Blue wire.
• Connect the orange wire to the illumination wire of the aftermarket radio.
If the aftermarket radio has no illumination wire, tape off the orange wire.
• Connect the light Green wire to the parking brake wire of the aftermarket
navigation radio.
• Connect the White and red RCA to the aftermarket radios AUX input.
from the 2nd 24-pin harness:
• Connect the Yellow RCA to the video in of the aftermarket radio.
from the 18-pin harness:
• Connect the Blue/pink wire to the VSS or speed sense wire of the aftermarket
navigation radio.
• Connect the Green/purple wire to the reverse wire of the aftermarket
navigation radio.
Installing the HYBl-02
1. With all the connections completed, plug the 16- and 18-pin harnesses into
the HYBL-02.
2. Plug the 24- & 18-pin harness into the vehicle side harness, and plug the
aftermarket radio harness into the aftermarket radio.
HYBL-02
(continued)
3. Reconnect the negative battery terminal.
4. Turn the ignition on, but do not start the car.
5. Press and hold the volume up button on the steering wheel for 5-seconds, this
6. If the vehicle came equipped with factory navigation press and hold the mode
testing and adjusting the HYBl-02
1. Turn the aftermarket radio on.
2. Set potentiometer all the way to the left.
3. Set radio to desired level.
4. Adjust the potentiometer to the right until the radio's audio level is high
5. Test BlueLink.
6. Reassemble dash and enjoy your new radio.
additional 12-pin harness (asWc-1 harness)
This 12-pin harness is to be used in conjunction with the ASWC-1 (not included).
Please refer to ASWC-1 instructions for programming.
will learn BlueLink.
button on the steering wheel for 5-seconds. (If vehicle did not come equipped
with factory navigation, skip this step)
and free of distortion.