From the 16-pin harness with stripped leads:
• Connect the Red wires to the ignition wire of the aftermarket radio.
• Connect the White wire to the left front positive speaker output of the
aftermarket radio.
• Connect the White/Black wire to the left front negative speaker output of the
aftermarket radio.
• Connect the Gray wire to the right front positive speaker output of the
aftermarket radio.
• Connect the Gray/Black wire to the right front negative speaker output of the
aftermarket radio.
• Connect the Brown wire to the mute wire of the aftermarket radio. If the
aftermarket radio does not have a Mute wire, tape up the Brown wire.
• The Blue/Pink will not be used in this application.
• The Green/Purple wire will not be used in this application.
• The Orange/White wire will not be used in this application.
• The Light Green wire will not be used in this application.
From the 1st 24-pin harness:
• Connect the Yellow wire to the 12-volt constant/battery wire of
the aftermarket radio.
HYBL-05
Connections to be made
• Connect the Black wire to the ground wire of the aftermarket radio.
• Connect the Blue wire to the power antenna wire of the aftermarket
• Connect the Orange wire to the illumination wire of the aftermarket radio.
• Connect the Light Green wire to the parking brake wire of the aftermarket
• Connect the White and Red RCA to the aftermarket radios AUX input.
From the 2nd 24-pin harness:
• Connect the Yellow RCA to the video in of the aftermarket radio.
From the 18-pin harness:
• Connect the Blue/Pink wire to the VSS or speed sense wire of the aftermarket
• Connect the Green/Purple wire to the reverse wire of the aftermarket
• Connect the Green wire to the radio's left rear positive speaker output.
• Connect the Green/Black wire to the radio's left rear negative speaker output.
2
radio. If the aftermarket radio does not have a power antenna wire tape
off the Blue wire.
If the aftermarket radio has no illumination wire, tape off the Orange wire.
navigation radio.
navigation radio.
navigation radio.