Using The Power Feeder Unit On A Spindle Moulder; Using The Power Feeder Unit On A Jointer Planer - Maggi STEFF 2032 Manual De Usuario

3-7 USING THE POWER FEEDER
UNIT ON A SPINDLE MOULDER
EN
During grooving operations, the two
spindle moulder guides must be
perfectly aligned.
During milling or profiling operations
the two guides must be as staggered
as required by the thickness to be
removed.
Place the feeder so that the toupie
miller is fitted between the middle
roller (B) and the entry roller (A).
44
3-8 USING THE POWER FEEDER
UNIT ON A JOINTER PLANER
All the rollers must act on the outgoing
side of the planer. The entry roller (A)
must be approximately 5-6 cm from
the workstand opening.
The pressure of the rollers on the
piece to be machined must be as light
as possible.
Fig.16
Fig.17