ScorpionExo EXO-100 Manual De Usuario página 4

EN
SpeedView® Sunvisor
Removal
While holding the sunvisor
with your other hand, depress
the button on the side bracket,
releasing the shield from the clasp.
Unhook the sunvisor from
the clasp, and remove it from
the side bracket.
Do the same to the opposite side
of the sunvisor, thereby detaching it.
You may now clean the sunvisor,
or replace it completely.
5
Securing and wearing
your helmet
Do not simply pull your helmet down onto your head like a hat. Your
ScorpionExo helmet should be worn as follows: Using both hands grab
®
the helmet's bottom rim while holding the chin straps with your thumbs.
Then "roll" the helmet onto your head starting at the forehead. Continue
rolling the helmet on towards the back of the head until it comes to rest
with your head fully in contact with the inner lining and cheek pads.
HOW TO USE CHINSTRAP
Nylon tab
While you are wearing your helmet,
Locking brace
grasp the notched arm of the
Open slot
chinstrap with your right hand, and
Notched arm the locking mechanism with your left
hand. Pull the nylon tab with your
thumb and forefinger to open the
locking brace. Insert the notched arm
into the slot. Release the nylon tab to
lock the arm in place. Adjust as
needed.
FIRMLY AND SECURELY FASTEN YOUR CHINSTRAP.
Check your chinstrap for tightness occasionally as vibration or wind may
loosen it.
Cleaning Your Helmet System
®
None of the components of your ScorpionExo™ helmet can be damaged
by water. Detachable liners are machine washable. Wash them with a mild
detergent in warm water and allow to air dry. Hand washing is recommended,
but machine washing is also permitted. Use the "delicate" cycle to prevent
the agitator from damaging the sweat-wicking material covering the liner parts,
we recommend to replace the parts in a washing bag.
Do not place lining parts in the dryer: Excessive heat may damage
the foam and coverings. The faceshield may be cleaned with
plastic polish or mild soap and water. The shell of your helmet
should be cleaned using only a mild detergent and water.
Warning
For your safety, it is important that you completely read the
owner's manual and all warning labels.
DO NOT
DO NOT ride without snugly fastening your chinstrap.
DO NOT clean your helmet with petroleum products, solvents,
benzene, thinner or cleaning agents.
DO NOT paint over your helmet's finish without totally protecting
and isolating the shock-absorbing liner and plastic parts.
Your warranty will otherwise be invalidated.
DO NOT drop your helmet from any height onto a hard surface.
This could cause damage to your helmet's finished and/or
decrease its ability to protect you.
DO NOT place your helmet on your motorcycle's rearview mirror:
The sharp pressure from the mirror's edge will compress and
damage the helmet's shock-absorbing liner.
DO NOT place your helmet on the motorcycle's seat or fuel tank.
It can easily roll off and hit the ground causing damage to
the helmet. It is best to place your helmet on the ground so it
cannot fall in any direction.
DO NOT ride with a scratched faceshield. This can impair your
vision, especially at night.
DO NOT modify any part of your helmet, e.g., drilling the shell or
cutting and pressing the shock absorbing liner. Installation of
sound systems, speakers and microphones reduces your helmet's
ability to protect you and is not recommended.
DO NOT use the helmet again if it has either been dropped or
involved in an accident. Replace it even if the damage is not
visible to the naked eye.
DO NOT wear a dark or tinted faceshield (including the
retractable SpeedView Sunvisor) in dark or poor visibility
TM
riding conditions.
DO NOT place your headliners and cheek pads in the dryer after
washing. Allow them to air dry.
DO NOT attempt to remove, change or replace your faceshield
while riding your motorcycle or ATV.
DO NOT use paint which requires heat curing.
Warranty
All ScorpionExo™ helmets have a warranty of 5 years.
Although there is no visible damage on your helmet, general wear
and tear over time may affect overall function of protective helmet
and increase the risk of injury in accident. It is advisable to replace
your helmet no later than every 5 years from purchase.
Should you have a warranty claim, go to your Scorpion dealer with
your invoice (this is you purchase proof, it's necessary in order to
start the warranty process). You can find our dealers' list on your
website: http://www.scorpionsports.eu/english/dealers/find-a-dealer/
find-a-dealer.html (choose your country and then the location)
The dealer will contact our after sales service and start the warranty
process in order to check and/or repair your helmet.
EN
6