Galax Pro 78221 Manual Del Propietario Y De Seguridad página 8

: For removal of the saw blade, proceed in reverse order.
NOTE
Installing the Vacuum Adaptor Hose
Insert the vacuum adaptor hose into the baseplate of the machine.
Operation
WARNING
must agree with the voltage specified on the nameplate of the machine.
Switch On and Off
a.Connect the plug to the power mains, the power-on indicator is illumed until
disconnect from the power mains.
b.Press the switch trigger and start the tool.
c.Release the trigger to turn the tool off.
: If you want the tool operate continuously, please press the
NOTE
lock-on button.
Adjusting the Cutting Speed
a.By turning the speed adjusting dial forward or
backward, it can reach your desired speed.
b.The speed should be adapted to the material being
cut in general, higher speed will allow you to cut
workpiece faster. However, the service life of the
blade will be reduced.
: Position "1" denotes the lowest speed.
NOTE
Position "6" denotes the highest speed.
Adjusting Cutting Angle
a.Loosen the screws of shoe by using hex wrench
for angle cutting adjustment which located on the
underside of the tool.
b.Move the shoe left or right and tilt it until the
desired angle (from 0⁰ to 45⁰) as shown on the tilt
angle scale.
c.Retighten the screws of shoe by using hex wrench.
.06.
: Observe correct main voltage! The voltage of the power source
Owner's Manual & Safety Instructions
JIG SAW