Sonde Signal; Set The Mode And Frequency Of The Pipeline Locator - Milwaukee M12 PL Manual Original

6.3 Sonde Signal

The sonde emits a large peak locate signal and two null points (forward or rear points) on each side of the peak.
The deeper the sonde is underground, the further apart these two null points will be.
The screen of the PIPELINE LOCATOR displays the peak and null points as:
Null Locate Points
As the user approaches the Sonde, from either direction, the locator will pick up the rear or forward null locate
point. The null locate points are identifi ed by a blue double circle
After the null locate point, an arrow will appear
Following the arrow
Peak locate signal

6.4 Set the mode and frequency of the PIPELINE LOCATOR

1.
2.
3. Make sure that the Sonde frequency matches sonde frequency set in the WIRELESS MONITOR or
PIPELINE INSPECTION APP.
ENGLISH
will lead the user over the peak locate signal where the sonde icon will appear.
 FREQUENCY
directing the user toward the sonde location.
13