Valley Electronics Daysy Instrucciones De Uso página 10

18
Cleaning
– Clean Daysy before and after every use
– Use a damp cloth to carefully clean the sensor on your Daysy. You can also
use a little alcohol or soap if you wish. Since your Daysy is not waterproof,
make sure that only the neck on the sensor and not the whole appliance
comes into contact with water.
Battery
– A single battery charge will last 1 to 2 months, depending on how often you
use your Daysy. To indicate that the battery is nearly empty, the activation
ring on your Daysy will flash at frequent intervals. Make sure you charge the
battery within a week. With normal use, the battery will still charge to 80% of
its capacity after 500 charging cycles.
– Note: You should not take measurements when your Daysy is charging.
Error messages/
Problems during use
My Daysy does not respond when I press the activation button.
Please charge your Daysy and try activating her again before contacting
our Customer Support.
The activation ring on my Daysy flashes blue at short intervals.
Please charge the battery on your Daysy.
My Daysy fails to start taking a measurement.
– Remove the USB cable before taking a measurement.
– If your Daysy makes a "beep-beep" sound, it means you have already
successfully taken a measurement today.
For more information, read our FAQ at daysy.me or contact our Customer Support.
19