ESCALADE Atomic G01354W Instrucciones De Montaje página 9

4 pcs - H9 Flat Washer
4 pcs - H12 Lock Nut
STEP 6:
Place P6 Playfield Support Braces onto bottom side of P5 Playfield. Slide P19 Support Rods into braces as shown
and attach each end of rods using H9 Flat Washer and H12 Lock Nut as shown in FIGURE 6.
Do not overtighten this hardware.
H12
12 pcs - H7 Phillips Round Head Screw
STEP 7:
Attach P8 Goal Box onto P2 End Apron using pre-drilled pilot holes with H7 Screws as shown in FIGURE 7.
Attach P9 Ball Catcher over the opening in P1 Side Apron using pre-drilled pilot holes with H7 Screws as shown
in FIGURE 7. Tighten, but do not strip out H7 screws.
Repeat procedure for other side of table.
NOTE: Make sure the round
opening for the ball return tube
is towords the floor (when table
is turned upright)
NOTE: Make sure the
opening is on this side.
All Rights Reserved.
© 2012 Escalade Sports
All manuals and user guides at all-guides.com
PARTS REQUIRED:
2 pcs - P6 Playfield Support Brace
2 pcs - P19 Support Rod
H9
H12
H9
P6
PARTS REQUIRED:
P1
P9
H7
P6
H9
H12
P19
2 pcs - P8 Goal Box 2 pcs - P9 Ball Catcher
H7
For Customer Service Call 1-888-996-2729
9
1 pc - T2 Wrench
P5
FIGURE 6
P19
H9
H12
P8
P2
H7
FIGURE 7