Universal Forest Products 298645 Instrucciones De Instalación

8 ft. Railing Kit with Aluminum Balusters
INSTALLATION INSTRUCTIONS
Tools Needed
• Drill/power screwdriver
• Miter or circular saw with carbide-tip blade
• Tape measure
• Carpenter's level
• Carpenter's pencil
• Safety glasses/goggles
• Gloves
Step 1: Measure the distance between posts and cut the rails to
size. For even spacing between the balusters and posts, be sure to
cut from both ends of rails.
Step 2: Place the moulded cap rail upside down on a flat surface.
Next, place one of the 2x4 rails into the moulded cap rail channel
so that the holes are facing up. Starting from either end, fasten the
top 2x4 to the cap rail using the (9) 3" screws through holes 1, 2, 5,
8, 11, 14, 17, 19 and 20. If rails are trimmed, predrill any additional
holes with a 1/8" drill bit and insert the screw into the next nearest
hole. (Fig. 1)
Step 3: Attach two support blocks on the bottom of the bottom
2x4 rail using 4" screws. The support blocks install under holes 7
and 14. If your rail was trimmed, divide the overall length by three
to determine support block spacing and install under the holes
closest to this measurement. If the holes have not been predrilled,
predrill with a 1/8" drill bit. (Fig. 1)
Step 4: Attach the (4) 2x4 railing brackets to the posts according
to the included instructions.
Step 5: Attach the bottom 2x4 rail, with the holes facing up, using
the 2x4 railing brackets. Insert the balusters into the predrilled
holes. (Fig. 2)
Step 6: Attach the cap rail by aligning the holes to the baluster at one
end of the rail and working your way to the opposite end, ensuring
that all of the balusters are secured between the two rails. (Fig. 2)
This brochure is for illustration purposes only. Use of this product must be in accordance with all local zoning and/or building codes. Consumer assumes all risks and liability associated with the use
of this product. For details on safe handling and warranty information, go to UFPI.com/ptinfo.
©2017 Universal Forest Products, Inc. All rights reserved.
Procedures
15 East Walnut St., West Building • Windsor, CO 80550 • 800-294-2171
DeckoRail is a registered trademark of Universal Forest Products, Inc. in the U.S.
Assembled in the USA with imported balusters. 8668_ENG_7/17
20 19 17 16 15 14 13 12 11
18
•
Cap
20 19 18 17 16 15 14 13 12 11
Cap Rail
•
•
•
Railing Brackets
StrRail3.ai
Top Insert Rail
10 9 8 7 6 5 4 3 2 1
•
Bottom Rail
10 9 8 7 6 5 4 3 2 1
•
•
Support Block
Fig. 1
StrRail2.pdf
•
Balusters
•
Bottom Rail
Support Block
Fig. 2