Technical Data; Safety Instructions; Symbols - Deltafox DG-CGS 7220 Traducción Del Manual De Instrucciones Original

GB

Technical data

Unit
Motor voltage ................................7,2 V
Rated speed .............................1100 min
Protection category............................IPX1
Grass-trimming blade
Cutting width .............................. 73 mm
Shrub-trimming blade
Cutting length .......................... 120 mm
Distance between teeth... approx. 8 mm
Weight (Art.: 80000735) .......approx 0.6 kg
Weight (Art.: 80000734) .......approx 1,2 kg
Sound pressure level
(L ) ..................... 73,3 dB(A), K
pA
Sound power level (L
guaranteed .............................. 86 dB(A)
measured .......83,5 dB(A); K
Vibration (a )
h
at handle .............1.52 m/s
Battery (Li-Ion)
Nominal voltage ...............7,2 V
Loading time..................... approx. 2,5 h
Charger ...............WJG-Y130502200WU1
Voltage input ...... 100 - 240 V~, 50 - 60 Hz
Nominal consumption ....................... 25 W
Voltage output...................................... 5 V
Recharging current ..................... 2200 mA
Protection class .................................
Protection category............................IPX0
The noise and vibration levels have been
calculated according to the norms stated
in the conformity statement. Technical and
optical alterations to serve progress may be
made without notice. All measurements, in-
structions and other data given in this man-
ual are therefore given without guarantee
of correctness. Legal claims made on the
basis of this manual are therefore excluded.
70
=3 dB
pA
)
WA
=1,99 dB
WA
, K=1.5 m/s
2
2 Ah
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another. The
stated vibration emission value may also
-1
be used for a preliminary exposure as-
sessment.
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
which the power tool is used. Try
to keep the exposure to vibrations
as low as possible. Examples of
measures to reduce vibration ex-
posure are the wearing of gloves
when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
2
be considered (for example, times
when the electric tool is switched
off and times when it is switched on
but running without any load).

Safety Instructions

This unit can cause serious in-
jury if not used correctly. Before
using the unit, carefully read
through the instruction manual
II
and familiarise yourself with all
of its controls.

Symbols

Symbols on the unit
Remember that the cutting equip-
ment will continue to move after
switching the unit off.
Attention!