Use As A Hedge Trimmer; Cleaning/Maintenance; Cleaning & Maintenance; Storage - Deltafox DG-CGS 7220 Traducción Del Manual De Instrucciones Original

GB

Use as a hedge trimmer

• Move the unit forward evenly.
• The double-sided cutting heads en-
able cutting in both directions or by
swinging the unit from side to side.

Cleaning/Maintenance

Leave any work not covered in
this manual to our Service Cen-
tre. Only use original parts. There
is a risk of injury!
Ensure that the safety key (
is removed before all tasks.
Never use cleaning agents or sol-
vents, which can cause irreparable
damage to the unit. Chemicals can
attack the plastic components on
the unit.
Wear gloves when handling the
blades (
of injury from cuts!
Clean and service the unit regularly as fol-
lows. This guarantees a long life for your
unit:
• Check the covers and guards for dam-
age and correct position. If necessary,
replace.
• Keep the ventilation slits, motor hous-
ing and handles on the equipment
clean. To do this, use a damp cloth or
brush.
• Always keep the blade clean.
After using the equipment, it is im-
perative to:
- Clean the blade
(with an oily cloth);
- Oil the blade shaft
with an oil can or
spray.
78
10/13). There is a risk
• Slight notches on the blades can be
evened out. For this, sand down the
blades with an oil stone. Only sharp
blades can cut properly.
• Blunt, bent or damaged blades must
be changed.
We are not liable for damage caused by
the use of the unit if the original cause
was improper repair or the use of non-
original parts or through use other than
that designated in this manual.

Storage

8)
• Keep the equipment in the blade
guard supplied, dry and out of reach
of children.
• Store the battery only in a partially
charged state. The state of charge
should be 40 – 60 % over a longer
storage period.
• Store the equipment between 10° C
and 25° C. During storage, avoid ex-
treme cold or heat so the battery does
not lose power.
• During a longer storage period, check
the state of charge of the battery and
recharge if necessary roughly every
3 months.
Disposal and the
environment
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.
Electrical appliances must not be
disposed of with the domestic waste.