Task 9: Creating Disk Arrays With Webpam Proe - Promise Technology VessRAID 1730s Guia De Inicio Rapido

Task 9: Creating Disk Arrays with WebPAM PROe

Setting up disk arrays with WebPAM PROe consists of the following actions:
• Logging into WebPAM PROe (below)
• Choosing a Language (page 26)
• Creating a Disk Array (page 26)
• Logging out of WebPAM PROe (page 30)
Logging into WebPAM PROe
1. Launch your Browser.
2. In the Browser address field, type the IP address of the VessRAID
subsystem.
Use the IP address you obtained in Task 8 (see page 20 or 22). Note that the
IP address shown below is only an example. The IP address you type into
your browser will be different.
Regular Connection
• WebPAM PROe uses an HTTP connection. . . . . . . . . . . . . . . .http://
• Enter the VessRAID's IP address . . . . . . . . . . . . . . . 192.168.10.85
Together, your entry looks like this:
http://192.168.10.85
Secure Connection
• WebPAM PROe uses a secure HTTP connection . . . . . . . . . .https://
• Enter the VessRAID's IP address . . . . . . . . . . . . . . . 192.168.10.85
Together, your entry looks like this:
https://192.168.10.85
You can also use the CLU or the LCD panel to create disk arrays
and logical drives. See Chapters 5 and 6 of the VessRAID Product
Manual on the CD.
Whether you select a regular or a secure connection, your login to
WebPAM PROe and your user password are always secure.
Task 9: Creating Disk Arrays with WebPAM PROe
Note
Note
24