Corsair RM Serie Manual Del Usuario página 5

ENGLISH
CORSAIR RM SERIES CABLE INFORMATION
Description
Connectors
ATX CABLE 24 PIN
610mm
EPS / ATX12V 8 PIN (4+4)
650mm
PCIe CABLE 8 PIN (6+2)
600mm
SATA CABLE (3 SATA - RIGHT ANGLE)
520mm 115mm 115mm
SATA CABLE (4 SATA - RIGHT ANGLE)
505mm 115mm 115mm
550mm 100mm 100mm
PATA CABLE (4-PIN)
450mm 100mm 100mm
Quantity
Total length 650W 750W
610mm
1 1
(± 10mm)
650mm
2 3
(± 10mm)
750mm
2 2
(± 10mm)
750mm
1 2
(± 10mm)
850mm
115mm
100mm
1 2
(± 10mm)
100mm 750mm
1 1
(± 10mm)
5
INSTALLING YOUR NEW RM SERIES POWER SUPPLY
Step 1: Removing Your existing PSU
WARNING! To ensure proper function, only use the DC cables included with your new PSU, unless your
850W old cables are genuine CORSAIR cables of the same type. Please confirm your existing cables' type before
using them!
If you are building a new system, skip to Step 2:
1. Disconnect the AC power cord from your wall outlet or UPS and from the existing power supply.
1
2. Disconnect all the power cables from your video card, motherboard and all other peripherals.
3. Follow the directions in your chassis manual and uninstall your existing PSU.
4. Proceed to Step 2.
3
Step 2: Installing the New Power Supply
1. Make sure the power supply's AC power cable is not connected.
2. Follow the directions in your chassis manual and install the power supply with the screws provided.
3. Connect the 24-pin (ATX) cable to the motherboard. Connect the 8-pin +12V (EPS12V) cable to
the motherboard.
2
a. If your motherboard has an eight-pin +12V socket, connect the eight-pin cable directly
to your motherboard.
b. If your motherboard has a four-pin socket, detach the four-pin from the eight-pin cable, and then plug this
four-pin cable directly to your motherboard.
c. Some motherboards will require a mix of 8+4 pins, use as many EPS12V cables as necessary and do not
mistake them for PCIe cables.
2
4. Connect the peripheral cables, PCI-Express cables, and SATA cables.
a. Connect the SATA cables to your SATA SSD or hard drive's power sockets.
b. Connect the PCI-Express cables to the power sockets of your PCI-Express video cards if required.
c. Connect the peripheral cables to any peripherals requiring a 4-pin connector.
d. Make sure all the cables are tightly connected. Be sure to save any unused modular cables for future
2
component additions.
5. Connect the AC power cord to the power supply and turn it on by pushing the switch to the ON position
(marked with "I").
1
6
ENGLISH