Walter WaluWinch Instrucciones De Montaje página 11

3
Fasten the unwinder by slotting the hole onto the stud.
Slide about 50 cm of the cover pulling strap into the guide, between the round
4
pin and the hub of the unwinder crown.
5 Insert the square pin on the carriage or handle into the slot provided in the
central part of the crown.
Fit the cover fastenings so that the cover complies with standard NF P 90-308.
6
VERY IMPORTANT: never tighten the cover using the unwinder.
If the ground is uneven (see sketch), insert the shims provided to make up the
gaps.
An optional stainless steel plate ZA100093 is available to place between the
ground and the fastening stud.
Fitting instructions
Level 0 of the
fastening stud
Ground
level 0