Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
How to Connect Using the Speaker Terminals
We recommend 18-gauge wire or thicker for runs up to 15 feet (4.5m), and 16-gauge wire or thicker for longer runs.
Separate the first few inches of the wire conductors. Strip off
speaker wire to expose the two conductors and tightly twist the wire strands.
WARNING: To prevent electrical shock hazard, always switch off the amplifier or receiver when making connections
to the speaker.
When making all connections, be sure to connect the + (red) on the speaker to the + (red) on the amplifier, and
the – (black) on the speaker to the – (black) on the amplifier.
IMPORTANT: Typically, one side of the wire is smooth.
Connect this side to the – (black) connection. The
other side has a rib or stripe. Connect this to the +
(red) connection.
Connecting the Subwoofer to Digital Home Theater Systems
Digital 5.1, 6.1 and 7.1 home theater electronics dedicate one channel (the ".1") to reproduce the special
low-frequency information (such as explosions and thunder) contained in digitally-encoded soundtracks.
Select "subwoofer-yes" from your receiver's set-up menu. Hooked up this way, the receiver's amplifier is relieved
of having to reproduce the difficult low bass signals that can drive the receiver into audible distortion.
Use an RCA cable (not included), as shown, to connect your digital receiver's subwoofer output to the subwoofer.
Set the crossover to the bypass position and connect to "line level in".
XB2
Powered Subwoofer Featuring BassTrac
CAUTION: Disconnect supply cord before replacing
fuse. For continued protection against risk of fire,
fuse. For continued protection against risk of fir
r eplace only with same type fuse.
r
A
A
TTENTION:
TTENTION:
TTENTION:
TTENTION:
Debrancher
Debrancher
avant
avant
de
de
Utiliser un fusible de r
Utiliser un fusible de
Utiliser un fusible de r
rechange de même type.
rechange de même type.
r
r
echange de même type.
All manuals and user guides at all-guides.com
–
+
®
crossover (Hz)
crossover (Hz
power
power
volume
volume
line level in
line level in
100
125
125
125
125
polarity
polarity
0º
0º
75
75
bypass
bypass
0
0
10
10
180º
180º
speaker level in
speaker level in
left
left
right
right
~
~
T 0.75A L 250V
T 0.75A L 250V
T 0.75A L 250V
V
V
remplacer
r
r
r
r r
emplacer
emplacer
le
le fusible.
~ ~
120V
120V
60Hz 0.75A
60Hz 0.75A
on
on
off
off
C
US
power
power
CAUTION
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
1
⁄
-inch (13mm) of insulation from the ends of each
2
Using the five-way binding posts: The binding
posts permit easy connection to banana plugs,
spade lugs, and bare wire. Insert the wire in the
hole and tighten.
back of receiver
subwoofer out
4
Publicidad
Tabla de contenido
