Wall Moun�Ng - LC-POWER LC-M49-DQHD-120-C-Q Manual De Usuario

6. Wall Moun�ng
This monitor only includes screws which may be used when a�aching
the monitor to a VESA 75*75mm type mount. No VESA mount or
moun�ng accessory is included.
1. Open the package, take out the product with foam s�ll a�ached,and
gently place it on a desktop or table.Remove the extra parts and the
foam covering the monitor. If the monitor was already a�ached to the
stand, remove the stand.
2. Remove the original screws x4( ) from the opening in the back of the
monitor.Follow the direc�ons received with your mount, stand, or accessory
and install the monitor on thewall or fixture as desired. Remember to use the
included NO.2 screws when a�aching anything to the back of the monitor.
Refer to the image( ) for correct screw placement.
Original Screws x 4
- Use only the M4*12mm/M4*7mm Screws (35 mm x 2 pcs,17mm x 2 pcs)
provided with this type of installa�on.
- Do not discard the original screws as these may be needed for future use.
3. Follow the direc�ons received with your mount, stand, or accessory and
install the monitor on the wall or fixture as desired.
1
2
1
Mount (Not included)
Eng-5
Use the 35mm
M4*12mm Screws x 2
2
Use the 17mm
M4*7mm Screws x 2