Pulmic INDUSTRIAL 35 Manual De Usuario página 10

PULMIC INDUSTRIAL 35
1. INTRODUCTION AND USES
Read this manual carefully before starting to use the sprayer and pay special
attention to the maintenance recommendations, as well as their use for
correct operation and useful life.
The company reserves the rights to changes the composition of the product
without prior notice as well as its technical characteristics. No claims can be
derived from the data and illustrations in this manual. The original manual
is written in Spanish, so it will prevail over the rest, in case of conflict or
contradictions between other languages.
This sprayer is specially designed for use with alkaline and neutral products
(pH scale min. 5 - 14 max.). It can be used for degreasers, detergents,
bactericides, viricides. In no case should it be used for the application of
acidic products. Always carry out the dosage of the products recommended
by the manufacturer.
2. COMPOSITION AND START-UP
Before starting work, you must finish charging the battery (during storage
it may have lost some of its charge). To do this, the battery must be
disconnected from the sprayer.
Plug the charger into the mains and connect it to the battery until it is fully
charged. When the charge level is full, the battery LEDs will stop flashing
and stay on.
The sprayer's operating temperature range is 1 ° to 50 ° C.
To start working with PULMIC INDUSTRIAL 35 turn the pressure regulator
and adjust it according to the nozzle and the desired flow rate.
DO NOT FORGET TO DISCONNECT THE SPRAYER WHEN
FINISHING WORK.
Watch the product commissioning video through the following
link or QR:
www.tiny.cc/startup-ind35
— 10 —
www.gruposanz.es