Technical Data; Especifications; Parts You Are Receiving - Swissmex Heavy Duty Serie Manual De Operador

3.2

TECHNICAL DATA

3.3 ASSEMBLY
3.3.1

Parts you are receiving

- Tank with pump handle, hose and shut-off
- 1 Spray lance
- 1 Nozzle
- Operator´s manual
3.3.2 How to assemble the sprayer:
Compression sprayers:
1.Remove all the parts from the box and
tank.
2.Place the applicator upright on a
table, assemble the spray tube with the
gun and tighten firmly.
3. Your sprayer is ready to use.
OPERATION
4.
Mix the solution in a separate container following the instructions of the product manufacturer.
Unscrew the pumping tube and remove it from the tank.
Pour the pre-mixed solution up to the indicated level marked in the tank.
Replace the pump tube and screw it tightly, then pressurize the unit.
Hold the sprayer by the handle or place it on the shoulder with the carrying strap and start applying.
Turn the nozzle to change the spray pattern.
Model
Tank capacity
Pump system
Pistón sleeve
Hose
Shut-off
Spray lance
Nozzle
Discharge at a 3 bar/min
Work pressure
Net weight
Weight with box
Dimentions 7.8x7.8x17.7" - 20x20x45.2cm 7.8x7.8x24.8" - 20x20x63.3cm
1

ESPECIFICATIONS

315175 - SW07
1.4 GAL / 5.5 L
Plastic piston
1.5" / 38 mm
Fiber vinil reinforced ID
Professional without filter
16.5" / 42 cm FVR
Plastic adjustable
20 oz - 600 ml
1 - 3 bar - 14.5 a 43 psi
2.8 lbs / 1.2 kg
3.5 lbs / 1.6 kg
2
2
316175 - SW08
1.8 GAL / 7 L
3.4 lbs / 1.5 kg
4.1 lbs / 1.9 kg
NOTE:
The pump tube must be tight
firmly otherwise the applicator
will leak and will not hold
pressure.
NOTE:
To ensure good performance use
original "SWISSMEX-RAPID"
spare parts.