Manual Mode - Overmax AD-06 Manual Del Usuario

B. The device will emit a sound and show a message on the
display (see: fig. 5). This will mean that you have exhaled
properly. Keep on blowing until you can hear a double „click".
At this moment stop blowing in, the device has collected the
sample of breath.
C.
The breathalyzer will start analyzing the data (fig. 5). Wait
for results.
EN

MANUAL MODE

A. When you can see „rdy" (abbreviated from „ready", see: fig.
4) and the device emits a short sound, press the left key (C)
to activate the manual mode.
B. The display will show a message (fig. 5) and emit a continuous
sound.
C.
Take a deep breath and blow into the mouthpiece continually.
Keep on blowing until you can hear a double „click". At this
moment stop blowing in.
D. The device starts analyzing the breath and shows"[--- „
(calculating). Wait for a while to see alcohol level result.
E.
The alcohol level result will be displayed in any format (‰,
%, mg / l) according to the BAC display format specific to
the given country. If you wish to change this format, press
the left key (C).
IMPORTANT!
•
In some cases the device may automatically prolong the sound
before blowing in and show the result 0.00. This happens
because a very low content of other substance in the sensor
may be measured if you do not use the product for a long
time. This being the case, retake the test.
•
In some cases the device may show the result
happens when the temperature of the test is too low or too
high. Before you retake the test, you may be required to wait
for a couple of minutes until the sensor inside the device
reaches the room temperature.
. This