NORTH STATES 4928 Instrucciones página 6

Lock Troubleshooting and Adjustment
If the lock alignment indicators do not line up as in gure 9D, please make the following
adjustments to make sure that the door panel can be auto-closed.
If the mark on the upper locking housing is displaced to the left (9A) or right (9B) then:
Loosen the screw on the upper locking housing as shown in gure 9C and adjust the gate until the marks
are aligned as shown in gure 9D.
FIGURE 9A
9C
Please use two screwdrivers when tightening
or loosening the screw.
If the upper locking housing is displaced upward (as in gure 9E) or downward (as in gure 9F):
Loosen the screw on the lower door hinge.
Press the door panel and the lower door hinge towards each other, as shown in gure 9G
until the two marks illustrated in 9D are aligned.
Retighten the screw on the lower door hinge.
9E 9F
9B
9D
Alignment marks are now in proper position.
Retighten screw on upper locking housing.
9G
Page 6
lower door hinge