Getting Started; Installation Checklist; Water Filter Installation - Whirlpool WRF954CIHB Manual De Uso

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.

Installation Checklist

✔ Electrical Power
Plug refrigerator into a grounded 3 prong outlet.
■
✔ Doors
If doors need to be removed during installation, see the
■
"Remove and Replace Doors" in the instructions.
Check that handles are secure and installed according to the
■
instructions.
Doors seal completely.
■
Refrigerator is level. (Remove base grille and adjust leveling
■
feet so they are snug against the floor.)
Doors are even across the top. (Use door alignment feature
■
if necessary.)
Base grille is properly attached to the refrigerator.
■
✔ Ice and Water System (on some models)
Connect refrigerator to a cold water supply with 35-120 psi
■
water pressure, as specified in the instructions.
Make sure the household water supply is connected and
■
turned on.
Check that the water supply line behind refrigerator is
■
not kinked.
Only use recommended water supply tubing, copper, or PEX,
■
as specified in the instructions.
Install water filter according to the instructions.
■
Flush water system with 3 gallons of water, as specified in
■
the instructions.
Check for water leaks at all connections.
■
Turn on ice maker if refrigerator is connected to water supply.
■
(If not connected to water supply, turn off ice maker.)
6

GETTING STARTED

✔ Final Checks
■
■
■
■
■
■
■
■
■
■
Install air filter according to instructions in corresponding
packaging.
Remove all shipping material.
Set temperature controls to the recommended setting.
Save instructions and other literature.
Send in Registration Card or register your product online.

Water Filter Installation

Locate the water filter compartment in the lower left-hand
side of the refrigerator compartment. Push on the right side
of the filter door to open.
Align the arrow on the water filter cap with the cutout notch
in the filter housing and insert filter.
Once the filter is inserted, turn the filter clockwise 90°
(1/4 turn) until it locks into the housing.
Push water filter door closed to latch.
Flush 3 gallons of water through the water system to clear air
from the water line and to keep the dispenser from dripping
and/or avoiding decreased dispenser flow.
NOTE: If the filter is not installed correctly, water may
dispense at a lower flow rate and there will be slower ice
production. Improper filter installation may also cause the
water filter housing to leak.