Ip Address Selection - Avigilon ENC-4PORT-2AI Guia De Instalacion

information on how to configure the connection, see the software user
guide.
The connection status LEDs show the progress in connecting to the
server and are described in the following table.
Table:Connection Status LED States
Connection
State
No Link
Obtaining IP
Address
Connecting to
a server
Upgrading
Firmware
Connected

IP Address Selection

Once connected to a network, the encoder will attempt to locate and
obtain an IP address from a DHCP server. If this fails, an IP address
will be selected using Zeroconf (APIPA).
If the IP address is set using Zeroconf, the IP address will be in the
169.254.* subnet. A static IP address can be set from the Avigilon
Control Center software, consult the software user guide for details.
Connection
Status LED
Off
One short
flash every
second
Two short
flashes every
second
Two short
flashes and
one long flash
every second
On
Description
Not physically connected to any
network device
Attempting to obtain an IP address
An IP address has been obtained
and is attempting to connect to the
server
Updating the firmware
Connected to the server
7