Electrical Connection - weltico EASYLED Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
pRECauTIOn: Turn the power off to the projector before connecting the cables.
a - If necessary, insert a 30/15mm
diameter pVC foam insulation
sleeve of 20 to 30 cm in length, in
order to avoid damage from frost
in the pVC pipe during very cold
weather.
c - Clamp the cable from the projector
to the box with cable clamp and the two
screws.
Wind the rest of the cable into the box
and close the cover.
pRECauTIOn: Switch off the power to the projector before replacing the light.
To replace a light carry out the operation in reverse order and then start again with a new light from chapter 5.

6) ELECTRICaL COnnECTIOn

PVC foam
insulation sleeve
7) InSTRuCTIOnS fOR REpLaCInG ThE LIGhT
b - Shorten the cable if necessary
but leave 30 cm of length from the
box. Connect the cable light to the
power cable from the electrical
box.
Cable clamp
and screw.
Page : 15

Publicidad

Tabla de contenido
loading

Tabla de contenido