Specific Safety Rules - Crafstman 900.11458 Manual De Instrucciones

5147391-00,01,11458 Revised

Specific Safety Rules

• Hold tool by insulated gripping
surfaces when performing an
operation where the cutting tool may
The label on your tool may include the following symbols.
V ..........................volts
Hz ........................hertz
min ........................minutes
current
......................direct current
.......................... Class II Construction
..............................safety alert symbol
WARNING: Some dust created by
power sanding, sawing, grinding,
drilling, and other construction
activities contains chemicals known to
cause cancer, birth defects or other
reproductive harm. Some examples of
these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement
and other masonry products, and
• arsenic and chromium from
chemically-treated lumber (CCA).
Your risk from these exposures varies,
depending on how often you do this type of
work. To reduce your exposure to these
chemicals: work in a well ventilated area,
and work with approved safety equipment,
such as those dust masks that are
SAFETY WARNINGS AND INSTRUCTIONS: CHARGING
1. This manual contains important safety
and operating instructions.
2. Before using battery charger, read all
instructions and cautionary warnings
on battery charger and product using
battery.
CAUTION: To reduce the risk of
injury, use charger only with this
product. Batteries in other products
may burst causing personal injury or
damage.
3. Do not expose charger to rain or snow.
4. Use of an attachment not
recommended or sold by Sears may
result in a risk of fire, electric shock, or
injury to persons.
5. To reduce risk of damage to electric
plug and cord, pull by plug rather than
cord when disconnecting charger.
6. Make sure cord is located so that it
will not be stepped on, tripped over, or
otherwise subjected to damage or
stress.
1/31/06 2:24 PM Page 4
contact hidden wiring. Contact with a
"live" wire will also make exposed metal
parts of the tool "live" and shock the
operator.
A ......................amperes
W ....................watts
....................alternating
n o ....................no load speed
.................... earthing terminal
.../min ..............revolutions or
specially designed to filter out
microscopic particles.
• Avoid prolonged contact with dust
from power sanding, sawing,
grinding, drilling, and other
construction activities. Wear
protective clothing and wash
exposed areas with soap and water.
Allowing dust to get into your mouth,
eyes, or lay on the skin may promote
absorption of harmful chemicals.
WARNING: Use of this tool can
generate and/or disburse dust, which
may cause serious and permanent
respiratory or other injury. Always use
NIOSH/OSHA approved respiratory
protection appropriate for the dust
exposure. Direct particles away from face
and body.
7. An extension cord should not be used
unless absolutely necessary. Use of
improper extension cord could result
in a risk of fire, electric shock or
electrocution.
a. Two-wire cords can be used with
2-wire or 3-wire extension cords. Only
round jacketed extension cords should
be used, and we recommend that they
be listed by Underwriters Laboratories
(U.L.). If the extension is to be used
outside, the cord must be suitable for
outdoor use. Any cord marked for
outdoor use can also be used for
indoor work. The letters "W" or "WA"
on the cord jacket indicate that the
cord is suitable for outdoor use.
b. An extension cord must have
adequate wire size (AWG or American
Wire Gauge) for safety, and to prevent
loss of power and overheating. The
smaller the gauge number of the wire,
the greater the capacity of the cable;
4
reciprocations per minute