Service; Trouble Shooting - Weed Eater WGS36 Manual Del Usuario

replacement batteries to avoid damage and personal injury.

SERVICE:

WARRANTY - During normal residential use, if this Grass Shear fails due to a
defect in material or workmanship within two years from the date of purchase,
Original Power, at its sole discretion, will repair or replace the unit free of charge.
For warranty services or questions please call (800) 540-5688.
This warranty applies only while this Grass Shear is used in the United States.
The warranty does not cover components that are subject to normal wear, such
as the blades and batteries. It also does not cover abuse, misuse, or use of the
product in a commercial setting. Replacement parts are available for purchase from
the retailer you bought your product from, or by calling us at (800) 540-5688.
Please read and follow the instructions for this product carefully.
This warranty gives you specifi c legal rights, and you may also have other rights,
which vary from state to state.
If you see any condition that may affect safe operation, or you have any questions,
contact our customer service number at: (800) 540-5688.

TROUBLE SHOOTING

Problem: Unit will not charge properly.
Solution(s):
Inspect charge connectors on unit and insure a proper connection.
•
Many outdoor or garage outlets in newer homes are protected by ground
•
fault (GFCI) circuits to prevent against electrical shock from moisture. Make
sure the charger is completely plugged into wall outlet and that the outlet is in
working condition (i.e. not temporarily disabled by a GFCI protector).
Remove blade pack per instructions in Figure 2. Slide back the battery door
•
and inspect that the battery pack is properly connected.
Problem: Cutting or run-time performance is diminished.
Solution(s):
Please follow the trimming techniques described in this manual for best
•
performance.
Inspect blades to make sure they are clean, free of obstruction(s) and
•
well lubricated. Refer to Maintenance section of manual on cleaning and
lubrication.
Make sure the unit is fully charged – see the Operations section of this manual
•
for charging details.
Problem: Thumb safety switch is diffi cult to hold on during use
Solution: The thumb safety switch need only be engaged when starting the unit.
There is no need to keep switch in forward position while using the product.
All manuals and user guides at all-guides.com
7