stayer VENTO2400B Manual De Instrucciones página 8

1.- Description and use of the
machine
1.- Air channeling tube
2.- Motor set
3.- Steering handle
4.- Power adjusting control
5.- Fastening belt buckle
6. Start/stop switch
7. Holding handle
8.- Holding belt
9.- Vacuum and blowing adjuster
10.- Collector bag support
11.- Trash collector bag
12.- Fixing plug
13.- Channeling tube
14.- Fixing screws
15.- Bag fastening hooks
The STAYER VENTO 2400 B electropor-
table blowing and aspiring machine may be
used only for aspiring together with a
collector bag, and blowing dry plant
materials within the scope of domestic
gardens. Any other kind of use such as
farming works, forestry o public use is
prohibited.
2.- Specific safety measures
Using earmuffs, protecting goggles and
particle protection mask is compulsory.
Using the trash collector bag is compulsory
when using the device as an aspirator.
Do not aspire still burning cigarette butts
and hot particles.
Never aim the air conduct at persons or
animals.
Always work leaving the power cable
behind.
Do not store the machine at outside
locations and always disconnect it when not
in operation.
All manuals and user guides at all-guides.com
ENGLISH
mounting holes
7
3.- Assembly
3.1- Channeling tube
The machine is packaged with the
telescopic air channeling tube 1
disassembled and folded. To couple the
tube to the machine's motor set 2, first
extend the tube 1 and then fix it to the motor
set 2.
Extend the tube to its maximum length by
pulling its end until the holes in the support
of the fixing devices 12 of the tube can be
seen.
Insert the two fixing plugs 12 that are
supplied, ensuring that they enter into the
support.
Place the channeling tube 1 on the motor
set 2, ensuring that the holes in both parts
engage.
Fix the two pieces by means of the two
screws and the two nuts that are supplied.
3.2- Collector bag
When aspiring, the collector bag 11 must be
compulsorily used. To assemble the bag 11
at the motor set 2:
1.- Place the circular support 10 for the
bag 10 at the air outlet hole ensuring
engagement of the holes.
2.- Fix the support by inserting it into the
guides and tighten each of the two
self-screwing screws 14 as supplied.
3.- Secure the bag 11 to the support by
tying it with the rope as included.
4.- The bag has two fastening loops
made of fabric. Fasten them to the
fastening hooks 15 at the motor set.
Always keep the bag 11 empty when
the machine is not in operation.
3.3- Machine holding belt
The equipment includes a belt 8 for
ergonomically positioning the machine.
For assembly of the holding belt: Open the
belt 8 by pushing its lock. Pass the belt
through the fastening ring 5. Adjust the
length of belt 5 according to the user's
stature and depending on how it is held
(hanging from or over the shoulder).
7