Maintenance And Service - stayer VENTO2400B Manual De Instrucciones

4.- Operating instructions
Place the holding belt on your shoulder or
over your shoulder such that the channeling
tube's wheels are resting on the floor or that
it is slightly suspended.
For aspiring, switch the operation switch 9
to the 'VAC' position and make sure that the
particle collector bag 11 is mounted.
For blowing, switch the operation switch to
the "BLOW' position, and make sure that
the particle collector bag 11 has been
removed.
Adjust the machine power. Adjust the power
level in accordance with the work to be
carried out by means of the continuous
regulation control 4. The minimum power is
obtained at mark number 1 and the
maximum at mark 6.
Connect the machine to the power grid. In
terms of electricity, the machine is of the
double-insulation type requiring 230 Vca at
5Hz and 11A when it operates at maximum
power.
To start the machine, simply push operation
switch 6.
Point the opening of the air channeling tube
1 towards the material to be swept by
blowing or to be aspired into the collector
bag 11.
Use the holding handle 8 and steering
handle 3 to direct the machine towards the
material to be worked on.
Always comply with the general and
specific safety rules as included in this
manual.
To stop the machine, simply stop pushing
the operation switch 6.
All manuals and user guides at all-guides.com
ENGLISH
8
Power
Air flow
Air speed
Capacity of aspiration bag
Acoustic power level L
Acoustic pressure level L (K=3 dB)
Vibration level a (K=1,5 m/s )
These data are valid for nominal voltages [U] 230/240
V ~ 50/60 Hz – 110/120 V ~ 60 Hz. Values may
change if the voltage was lower, and in specific
versions for certain countries.
In view of that the commercial denominations of some
apparatus may vary, pay attention to the article
number on the specification plate on your apparatus.
8

5.- Maintenance and service

Maintenance works carried out by the user
are limited to proper cleaning of the
equipment. Address yourself to the official
technical service through your authorized
dealer for any other operation.
Always disconnect the machine before
cleaning it.
For cleaning use a soft cloth slightly wetted
with slightly soaped water.
Technical specifications
( k= 3db)
WA
PA
H
6.- E C D e c l a r a t i o n
Conformity
We declare under our own sole
responsibility that this product is in
accordance with the following standards or
standardized documents: IEC 60745, EN
6 0 7 4 5 a c c o r d i n g t o r e g u l a t i o n s
2 0 0 6 / 4 2 / E C ,
2006/95/EC.
Ramiro de la Fuente
Director Manager
2400 W
3
13 m / min
210 km/h
35L
109 dB(A)
98 dB(A)
2
2 6 m/s
o f
2 0 0 4 / 1 0 8 / E C ,