Uline H-4521 Manual De Instrucciones página 2

Figure 2
13
Figure 3
Tension Knob
Hand Grip
Figure 4
PAGE 2 OF 9
ASSEMBLY CONTINUED
12
11
10
2. Align armrest with holes on bottom of seat cushion.
Use one 1/4 x 1/" screw (12) and two 1/4 x 1/"
screws (13) to attach. Repeat on opposite side.
(See Figure 2)
NOTE: Use Allen wrench to tighten all screws.
3. Align mechanism with holes on bottom of seat
cushion with tension knob facing the front of seat.
Use four 5/16 x 1" screws (11) to attach. (See Figure 3)
4. Attach hand grips to levers on mechanism.
(See Figure 3)
5. Position back support in slot between bottom of
seat cushion and mechanism holes and use three
5/16 x 3/4" screws (10) to attach back support to
mechanism. (See Figure 4)
0721 IH-4521