Uline H-616 Manual Del Usuario página 2

NOTE: Attach marker tray to board frame
before mounting board on wall.
1. Center marker tray along the bottom board frame
(horizontal or vertical orientation). (See Figure 1)
Figure 1
Horizontal
2. Insert marker tray at an angle into back channel of
board frame. Rotate tray up until it is fully engaged.
(See Figure 2)
Figure 2
NOTE: Before mounting board to wall, see
instructions above on how to attach optional
marker tray to board.
1. Determine board location. Position top hanging
brackets. Mark center hole of each hanging bracket
6" from outside edge of board and 7/8" down from
top of board (A). (See Figure 4)
2. Drill holes for each hanging bracket in marked
locations on the wall using a 1/4" drill bit. Remove
screw from wall anchor. Insert wall anchors into
holes flush with wall. Insert screws with washers
through hanging brackets into wall anchors (B).
Tighten firmly. (See Figure 4)
3. Holding the board at approximately a 15° angle,
place the channel in the back of the frame over the
hanging brackets. Lower the board so it is flush to
the wall (C). (See Figure 4)
PAGE 2 OF 9
OPTIONAL MARKER TRAY INSTALLATION
Vertical
MOUNTING
3. Align tray end caps and fasten with No. 6-32 x 3/8"
screws. (See Figure 3)
Figure 3
Figure 4
c a t i o
d L o
B o a r
z o n t a
( H o r i
n t )
M o u
d
B o a r
t i o n
L o c a
i c a l
( V e r t
n t )
M o u
7/8"
n
1/4" Bit
l
15°
A
6"
B
C
0521 IH-616