Uline H-616 Manual Del Usuario página 3

4. To position bottom "L" brackets, mark wall 1⁄" up
from bottom of board, 6" from each outside edge
(D). (See Figure 5)
5. Drill holes in marked locations using a 1/4" drill bit.
Remove screw from wall anchor. Insert wall anchors
into holes flush with wall. Insert screws with washers
through "L" brackets into wall anchors (E).
(See Figure 5)
6. Hang board and mark frame through hole in each
"L" bracket. Remove board and drill pilot hole at
each mark with 1/8" drill bit. Re-hang board and
insert #8 x 1/2" truss-head screw through each "L"
bracket and into pilot hole in frame (F). Tighten firmly.
(See Figure 5)
1. Clean board prior to first use with mild soap and
water (do not use abrasive cleaners). Rinse and dry
thoroughly with a soft cloth.
2. Use only dry erase markers. Other markers may
permanently damage the writing surface. For best
erasing results, replace markers at least once a year.
3. Use a clean eraser to remove dry-erase ink from the
board surface. Occasionally, use dry erase board
cleaner to remove grease, dirt and dry erase ink
residue that may build up on the board surface.
PAGE 3 OF 9
MOUNTING CONTINUED
Figure 5
MAINTENANCE
4. Avoid leaving marks on the board surface for
5. Do not use adhesive tape on board surface.
1-800-295-5510
uline.com
n
c a t i o
d L o
B o a r
prolonged periods. Dry erase ink may become
difficult to erase over time.
6"
1/4", 1/8 Bit
0521 IH-616
D
E
F