Dahua Technology ARD323-W2 Manual De Instrucciones página 2

Table 5-1 Installation items
No. Item name No. Item name
1 Door 1 4 Expansion bolt
2 Door 2 5 Attachment panel
3 ST3 × 18 mm self-tapping screw 6 Magnet
Step 1 Drill 4 holes in door 1 and door 2 according to the hole
positions of the attachment panels.
Step 2 Put the expansion bolts into the holes.
Step 3 Align the screw holes on the plate with the expansion bolts.
Step 4 Fix the attachment panels with ST3 × 18 mm self-tapping
screws.
Step 5 Put the door detector into the attachment panel from top to
bottom.
6
Door Detector Configuration
6.1 Configuring the Door Detector
On the Hub interface, select the door detector as needed from the
accessory list, and then you can configure the parameters of the door
detector.
Table 6-1 Door detector parameter description
Parameter Description
View device name, type, SN and device
●
model.
Device Configuration
Edit device name, and then tap Save to
●
save configuration.
Select the area to which the door detector is
Area
assigned.
The accessory located in the 24 h protection
zone is always active whether the security
24 H Protection Zone
system is configured in the armed mode or
not.
Enable the home mode, and then the
Home Mode selected accessories under the hub will be
armed.
Enable the Delay Mode under Home Mode,
the selected accessory under the hub will be
armed and the alarm will not be triggered until
Delay Mode under Home Mode the end of customized delay time.
Only enable Home Mode first can Delay
Mode under Home Mode take effect.
The system provides you with time to
●
leave or enter the armed zone without
alarm.
Delay Time Select from 0 s to 120 s.
●
The arming mode will be effective after the
delay time.
External Detector Access Connect the wired peripheral with the cable.
When an alarm is triggered, the accessories
Alarm-speaker Linkage will report the alarm events to the hub and
alert with siren.
When an alarm is triggered, the accessories
Alarm-video Linkage will report the alarm events to the hub and
then will be linked with videos.
Parameter Description
Video Channel Select the video channel as needed.
Signal Strength Detection Test the current signal strength.
Detector Test Detect whether the accessory works.
Select from high, low, and automatic.
●
The higher the transmission power, the
●
Transmit Power
farther the transmission and the higher
power consumption.
Cloud Update Update online.
Delete the online accessory.
Delete
Go to the Hub interface, select the
accessory from the list, and then swipe left
to delete it.
6.2 Viewing Status of the Door Detector
On the Hub interface, select the door detector as needed from the
accessory list, and then tab to view the status of the door detector.
Table 6-2 Status
Parameter Value
Temperature The temperature of the environment.
The signal strength between the hub and the door
detector.
: Ultra low.
●
: Low.
Signal Strength ●
: Moderate.
●
: High.
●
: No.
●
The battery level of the detector.
: Fully charged.
●
Battery Level : Sufficient.
●
: Moderate.
●
: Insufficient.
●
Anti-tampering Status Anti-tampering status of the door detector.
Online and offline status of the door detector.
Online Status : Online.
●
: Offline.
●
Entrance Delay Time
Entrance and exit delay time.
Exit Delay Time
Open or close status of the door.
Door Status : Open.
●
: Close.
●
Active status of the 24 h protection zone.
24 H Protection Zone
: Enable.
●
Status
: Disable.
●
Program Version The program version of the door detector.