Getting Ready - Logitech ClickSmart 820 Manual De Instrucciones

2

Getting Ready

1. Insert the four AAA alkaline camera batteries.
2. Optional: Insert a SmartMedia
into the memory card slot. Be sure the memory card is correctly positioned
with the card's metal contacts facing away from you, as shown in the picture.
Push the card all the way in and close the door. If the SmartMedia door is slightly ajar after
you close it, the memory card is not correctly positioned. (To remove the memory card,
open the door and press on the card to eject it.)
3. Insert the wrist strap and lens cap.
4. Install the Logitech camera software using your computer's CD-ROM drive.
Follow the on-screen instructions. (The camera language defaults to English,
but you can change it during software installation.)
3
Taking Pictures and Videos
1. Press the Power button to turn on the camera.
2. To take a picture, set the Picture/Video switch to "Picture." Then press the Shutter
button to take a picture. If the lens cap is left on, the camera emits a warning sound
and the Lens-cap-on icon appears on the camera display.
3. For videos, set the Picture/Video switch to "Video." Then press and hold the Shutter
button to take a video. The Video-on LED blinks green to indicate the camera is recording.
(This LED will blink more rapidly when the camera begins to run out of memory.)
Release the Shutter button to stop recording. When not in use, the camera turns
itself off after two minutes to conserve battery power. To switch the camera off,
press the Power button.
2
English
™
memory card (not included with the camera)
Optional
™
Smart-Media Card