HQ-Power PSI Serie Manual Del Usuario página 5

Step 2: Connect the included cables to the battery.
Connect the black wire to the black connection on the back of the inverter (DC input, see fig.) and to the negative
battery terminal (-). Connect the red wire to the red connection at the back of the inverter and to the positive battery
terminal (+).
An incorrect connection can damage the inverter and will void the warranty. The 150W inverter is equipped with a
fused car plug and can easily be used in the car.
power LED
overload, low battery,
overheating LED
Do not extend the included cable as this can lead to a high voltage loss or cable overheating!
Step 3: Connect the device.
You can extend the connection cable to the device without problems.
Step 4: switch on the inverter.
The green LED lights up. The inverter delivers an output power of 240VAC.
Step 5: Switch on the connected device.
Respect the order of the aforementioned steps. To switch off the system, proceed in reverse order.
6. Earthing
The rear panel of the inverter is equipped with a terminal fitted with a wing nut. This terminal is connected to the case
of the inverter and also to the earthing terminal of the AC output socket.
The chassis earthing lug should be connected to an earthing point, which will vary depending on where the power
inverter is installed. In a vehicle, connect the chassis ground lug to the chassis of the vehicle. In a boat, connect to
the boat's grounding systems. In a fixed location, connect to earth.
PSI SERIES_v2
power switch
chassis earthing
- 5 -
AC output socket
terminals
fan
HQPOWER