Assembly Procedure - Skoda 5J0 054 907 Manual Del Usuario

CENTRAL LOCKING REMOTE CONTROL
The accessories are intended for professional fitting. Škoda Auto recommends the fitting to
be carried out by its contract partners.
The control is not connected to data lines, and therefore, its diagnostics by the instrument
VAS is not possible.
The set includes (fig. 2)
Part name
Remote control electric installation harness
LED
Control unit
Fuse 7.5 A
Remote control
1-pole terminal board (plug type)
2-pole terminal board (plug type)
1-pole terminal board (socket type)
2-pole terminal board (socket type)
Connecting tube
Velcro fastener (for fastening the control unit)
Code label
Special tooling:
Set of punchers

Assembly procedure

Important. For vehicles with right steering, the pictures 3 - 5 are mirror inverted!
- During the fitting, the negative pole of the car battery must be disconnected (if there is a
coded car radio in the vehicle, find out its code first).
- Remove:
- the attenuator panel and fuse panel cover.
(see Bodywork and fitting jobs - group of repairs 70)
- release the central control unit of the car, the fuse panel and the light switch.
Before gluing the remote control parts (LED and control unit), make sure to clean and
degrease the chosen place with a suitable cleanser. Leave it for 10 minutes to dry. Do
not touch the spot prepared in this way any more.
Pieces Position
1 A
1 B
1 C
1 D
2 E
1 F
2 G
1 H
2 J
1 K
2 L
1
GB