DeWalt DC740 Manual De Instrucciones página 13

Dual Range Gearing (Fig. 3)
The dual range feature of your driver/drill allows you to shift gears for
greater versatility.
To select the low speed, high torque setting, turn the tool off and
permit to stop. Slide the gear shifter (D) forward (towards the chuck)
(position 1), as shown. To select the high speed, low torque setting,
turn the tool off and permit to stop. Slide the gear shifter back (away
from chuck, position 2).
NOTE: Do not change gears when the tool is running. If you are
having trouble changing gears, make sure that the dual range gear
shifter is either completely pushed forward or completely pushed
back.
OPERATION
WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. 4, 5)
NOTE: For best results, make sure
FIG. 5
your battery pack is fully charged.
To install the battery pack into the
tool handle, align the notch inside
the tool's handle with the battery
pack and slide the battery pack
firmly into the handle until you
hear the lock snap into place as
shown in Figure 5.
To remove the battery pack from
the tool, press the release buttons
All manuals and user guides at all-guides.com
(F) and firmly pull the battery pack out of the tool handle. Insert it into
the charger as described in the charger section of this manual.
Keyless Single Sleeve Chuck (Fig. 6)
Your tool features a keyless chuck
with one rotating sleeve for one-
handed operation of the chuck. To
insert a drill bit or other accessory,
follow these steps.
1. Lock the trigger in the OFF
2. Grasp the black sleeve of the
3. Insert the accessory about 3/4"
To release the accessory, repeat step 2 above.
accessory) by gripping the front part of the chuck and turning the tool
on. Damage to the chuck and personal injury may result. Always lock
off trigger switch when changing acces sories.
Be sure to tighten chuck with one hand on the chuck sleeve and one
hand holding the tool for maximum tightness.
11
FIG. 6
position.
chuck with one hand and
use the other hand to secure
the tool. Rotate the sleeve
counterclockwise far enough to
accept the desired accessory.
(19 mm) into the chuck and tighten securely by rotating the
chuck sleeve clockwise with one hand while holding the tool with
the other. Your tool is equipped with an automatic spindle lock
mechanism. This allows you to open and close the chuck with
one hand.
WARNING: Do not attempt to tighten drill bits (or any other