Tabla De Contenido; Important Safety Instructions For All Battery Packs - DeWalt DC740 Manual De Instrucciones

CAUTION: When not in use, place tool on its side on a stable
surface where it will not cause a tripping or falling hazard.
Some tools with large battery packs will stand upright on the battery
pack but may be easily knocked over.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ................... volts
Hz ................. hertz
min ............... minutes
or DC ... direct current
................. Class I Construction
..................... (grounded)
................. Class II Construction
(double insulated)
.../min ........... per minute
BPM ............. beats per minute
IPM ............... impacts per minute
RPM ............. revolutions per
minute
sfpm ............. surface feet
..................... per minute
SPM ............. strokes per minute
Important Safety Instructions for All
Battery Packs
When ordering replacement battery packs, be sure to include catalog
number and voltage. Consult the chart at the end of this manual for
compatibility of chargers and battery packs.
All manuals and user guides at all-guides.com
The battery pack is not fully charged out of the carton. Before using
the battery pack and charger, read the safety instructions below. Then
follow charging procedures outlined.
• Do not charge or use battery in explosive atmospheres,
A ......................amperes
W .....................watts
or AC ..........alternating
• NEVER force battery pack into charger. DO NOT modify
current
or AC/DC ...alternating
........................or direct
current
• Charge the battery packs only in D
n o ....................no load
• DO NOT splash or immerse in water or other liquids.
speed
• Do not store or use the tool and battery pack in locations
n ......................rated
........................speed
.....................earthing
pack for any reason. If battery pack case is cracked or damaged, do
terminal
not insert into charger. Do not crush, drop or damage battery pack.
.....................safety alert
Do not use a battery pack or charger that has received a sharp blow,
symbol
been dropped, run over or damaged in any way (i.e., pierced with a
nail, hit with a hammer, stepped on). Electric shock or electrocution
may result. Damaged battery packs should be returned to service
center for recycling.
NOTE: Battery storage and carrying caps are provided
for use whenever the battery is out of the tool or charger.
Remove cap before placing battery in charger or tool.
battery so that metal objects can contact exposed
4
READ ALL INSTRUCTIONS
such as in the presence of flammable liquids, gases or dust.
Inserting or removing the battery from the charger may ignite the
dust or fumes.
battery pack in any way to fit into a non-compatible
charger as battery pack may rupture causing serious
personal injury. Consult the chart at the end of this manual for
compatibility of batteries and chargers.
WALT chargers.
E
where the temperature may reach or exceed 105 °F (40 °C)
(such as outside sheds or metal buildings in summer).
DANGER: Electrocution hazard. Never attempt to open the battery
WARNING: Fire hazard. Do not store or carry