Skil 3100-10 Manual De Instrucciones página 11

Attaching Sander Insert
The following Skil Sander Models may be used with the sander
insert: Model 7500.
BEFORE USING THE SANDER: Read the
!
WARNING
instruction manual that came with the sander.
From among the loose parts, locate the following hardware (Fig. 1).
Hardware Kit Sander Insert
Item Description
S1 Sander Insert
S2 Sander Bracket Right
S3 Sander Bracket Front
S4 Sander Bracket Left
S5 Hex-head Screw (long)
S6 Wing Nut
S7 Washer
S8 Retaining Bracket
S9 Sander Fence
S10 Wear Bracket
S11 Hex-Head Screw (short)
1. Make sure the sander switch is in the OFF position and the cord
is unplugged.
2. Install sanding belt per the sander's original instruction manual.
3. Attach sander wear brackets S10 to insert. (Fig. 1)
4. Fasten the right and left sander brackets S2, S4 to the insert
using 4 hex-head-screws S11, 4 washers S7 and 4 wing nuts S6
as shown. (Fig. 1)
5. Insert the sander, making sure that the tabs YY on the flat
brackets engage with the four slots XX on the sides of the sander
(Fig. 2).
6. Install the front bracket S3 using 2 hex-head screws S11, 2
washers S7 and 2 wing nuts S6 as shown. Be sure the sander is
fimly installed and cannot work its way loose.
7. Attach retaining bracket S8 onto bottom of insert using hex-head
screws S11, washers S7 and wing nuts S6 as shown.
8. Lift the red latch lever Y located at front of the table opening and
remove blank insert (Fig. 3).
9. Slip tabs X on edge of insert into rear of table opening. (Fig. 4)
10. Lower the front edge of insert S1 into table and lower the red
latch lever Y (Fig. 4 & 5).
11. Install the fence S9 using the (2) Wing nuts S6, (2) Hex-head
screws S5 and (2) Washers S7 (Fig. 1)
12. Lock the sander switch to the ON position.
13. Make sure the main table power switch is in the OFF position.
14. Insert the sander electrical plug into the accessory power outlet.
15. See the section on "Operation of the Accessory Power Outlet".
16. Operate the sander in accordance with the sections entitled
"Sander Safety" and "Operation of a Sander with the Sander
Insert" in this manual.
FIG. 3
All manuals and user guides at all-guides.com
Quantity
1
1
1
1
2
10
10
S5
1
1
2
8
(Tool Not Included) / (Outil non joint) / (Herramienta no incluida)
Y
11.
FIG. 1
S9
S6
S7
S4
x5
FIG. 2
XX
YY
S4
FIG. 4
S11
S8
S7
S6
S11
S1
S10
S2
S7
S6
S3
2
2