SRAM ROCK SHOX Reverb Manual Del Usuario página 52

Thread the syringe into the remote bleed port.
9
While holding the syringe upright, gently pull up on the syringe plunger and push the remote actuator at the same
time. This will remove air bubbles from the remote.
Then, push on the syringe plunger which will, in turn, extend the remote actuator. This will force oil into the remote.
Cycle the syringe plunger and remote actuator through this process until no more air bubbles transfer from the
remote to the syringe.
Complete the bleed with a firm push on the syringe plunger that leaves the remote actuator fully extended.
Unthread the syringe from the remote.
10
Use a T10 Torx to thread the bleed screw into the bleed port and tighten it to 1.7 N m (15 in-lb).
11
Use a T25 Torx to loosen the remote clamp bolt. Rotate the remote to the desired position on the handlebar.
12
Tighten the remote clamp bolt to 5-6 N m (43-52 in-lb).
Turn the speed adjuster to the desired setting.
13
Spray isopropyl alcohol on the remote assembly and clean it with a lint free rag.
14
Remove the bicycle from the bike stand.
15
Set the seatpost to the desired height then tighten the seatpost binder bolt/quick release to the frame
16
manufacturer's recommendation. Do not exceed 6.7 N·m (60 in-lb).
This completes the Reverb Remote Assembly Quick Bleed.
SRAM LLC
Pull - Syringe Plunger
Push - Remote Actuator
Push - Syringe Plunger
Pull - Remote Actuator
3