Connecting And Use - Edenwood FOG Instrucciones De Uso

B
Product usage

Connecting and use

• The controls and connections are located on the back of the unit.
• Plug the unit into a suitable mains socket.
• Use the ON/OFF switch to turn on the amplifier; the red LED indicator will light up and
the unit will take approximately 8 minutes to heat up.
• The green LED indicator will light up when the unit is ready for use.
• If you are using the unit's controls, press the red button to generate fog. Press the same
button again to stop the fog.
• If you are using the remote control, press the remote control button to generate fog. Press
the same button again to stop the fog.
• Use the level window at the back of the unit to constantly check how much fluid is left.
• The red LED indicator will automatically turn on, each time the machine needs to heat
up to return to the correct operating temperature.
Every now and again, a small amount of fog may be emitted during use or when the machine is
switched off. This will occur if the unit has finished heating up and the red indicator is still lit.
The unit becomes very hot during use. Do not touch it and stay at least 5 metres away from
the unit's nozzle. Allow the unit to cool completely before handling it.
Should any problems occur with your unit, consult the "Troubleshooting" table. If none of
the tips help solve your problem, take your unit to your seller for assistance.
15 EN