Dip Switch Configuration - Hotpoint AH11E07D Manual Del Propietario Y Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Dip Switch Configuration

REMOVING THE FRONT PANEL
Dip switch controls are located behind front panel,
through an opening below the control panel. To
access,remove front panel.
DIP SWITCHES
CONFIGURATIONS
configurations and functions of each dip switch
position.
(Factory default switch positions (darkened portion)
shown)
No.
Temperature Display in F°
Fan Continuous Run for Cooling
* NOTE:
Wall Thermostat Enable
control the unit. For proper wall thermostat operation,
Low temp. Protection (optional)
fan motor and electric strip heat will turn on and warm
the room to 40°F. The fan and heater will shut down a
short time after the temperature is satisfied.
Electric Heat Only (for heat pump unit only)
6
2. Then lift up
1.
bottom to release
it from the tabs .
DIP SWITCH CONFIGURATION TABLE
UP (ON)
Temperature Display in C°
Fan Cycle for Cooling
Dip switches are accessible without opening the
Unit must be powered OFF to change dip switch
settings.
1 2 3 4
1 2 3 4
1 2
DOWN (OFF)
Heat and Cool Fan CON/CYC Dip-switches
while the unit is in heating and cooling mode.
CON(Continuous)
when the temperature setting has been satisfied. This
switch helps to maintain the room temperature closer
to the thermostat setting.
CYC(Cycle)
This setting allows the fan to cycle on and off with the
compressor or electric heater. The fan stops a short
time after the temperature setting is satisfied.
Setpoint Temperature Limits
Do Not Adjust
UP(ON)
1 2 3 4
DOWN(OFF)
Heating type
Temperature display type
Control type
Setpoint limit 1
Setpoint limit 2
Fan CON/CYC for heating
Fan CON/CYC for cooling
Low temp. Protection
Remarks
select unit thermostat set point range.
49-5000041 Rev. 6

Publicidad

Tabla de contenido
loading

Tabla de contenido