All manuals and user guides at all-guides.com
Introduction
JetPort 5801 is a one-port RS232/422/485 to Wireless Device Server. The Wireless LAN
solution is 802.11b/g with up to 54Mbps bandwidth. Give you an easy solution to the
hard-to-wire or moving environment. JetPort 5801 comes with powerful windows utility,
JetPort Commander, which supports device discovery, group configuration and monitoring.
Additional management features include HTTPS, SSH, Event Alarms and several types of
WLAN data encryption.
Hardware Installation
1. Unpack the box, you will find
JetPort unit and Antenna
Power adapter (100-240VAC)
Mounting kit, Foot pad
Quick Installation Guide
Software CD-ROM
2. Mounting the unit
Antenna: Screw the attached Antenna to the unit.
Wall-mount: Use the screws to mount the ear on the wall.
Din-Rail: Screw the din-rail to the ears and mount to the rail.
3. Power the unit and connect to network and serial
device
3.1 Connect the PWR1 / PWR2, the unit will power on.
When the unit is ready, the LED turns Green.
3.2 Connect JetPort 5801 to LAN interface by standard
10/100M Ethernet cable to configure the WLAN settings
for the WLAN interface.
3.3 After configuring the WLAN settings,
unplug the Ethernet cable or power reboot the
JetPort to activate the WLAN connection.
WLAN, Antenna
LED
PWR1, PWR2, LAN,
WLAN, Serial TX/RX
H/W Reset Button
1 RS-232/422/485
DB9 Serial Connector
Pin #
RS232
RS422
1
DCD
RXD-
2
RXD
RXD+
3
TXD
TXD+
4
DTR
TXD-
5
GND
GND
6
DSR
7
RTS
8
CTS
9
RI
RS232 mode act as DTE
DIP 1
DIP 2
120ohm Termination Configuration
ON
ON
120ohm Terminator for Long Distance 4-wire RS485 / RS422
ON
OFF
This setting will cause ERRORS
OFF
ON
120ohm Termination for Long Distance 2-wire RS485
OFF
OFF
No Termination for RS232/422/485 (short distance)
10/100M Ethernet
PWR 1: Terminal Block, 12-48VDC
PWR 2: Power Jack, 12~48 VDC
( V+ V-
)
PWR1 PWR2
Mounting Ear
Long Distance
No
RS422/485 120ohm
1 2
Termination
1 2 3 4 5
6 7 8 9
RS485 (4 wire)
RS485(2 wire)
RXD-
RXD+
TXD+
DATA+
TXD-
DATA-
GND
GND