Disconnecting The Ipod - Toyota PT546-52121 Manual Del Propietário

NOTICE
• To resolve most problems
when using your iPod with
the TOYOTA Audio system,
disconnect your iPod from the
vehicle iPod connection and
reset it.
• For instructions on how to
reset your iPod, refer to the
User Guide of your iPod.
• Connect the Dock connector
directly to the iPod with
Dock connector port. Do not
connect it via the iPod Dock
or other connection.
• When the iPod is connected
to this unit, sound will
also be heard from the
headphone of the iPod.
Disconnect the headphone
from the iPod before use.
• If you install an audio
system other than a TOYOTA
Genuine Audio, you will
not be able to use the USB
connector.

• When you are using iPhone by
the multitasking, according to
the application under use, it
might not be able to charge a
battery.
NOTICE
If after updating iPod or iPhone
with latest software/firmware
(iTunes), if this product does not
recognize the connected iPod/
iPhone or otherwise behaves
erratically, follow the steps below.
1. Disconnect the iPod/iPhone
cable and then reconnect it.
2. Turn the iPod/iPhone off and
then turn the device back on
again.
3. Disconnect the cable from the
iPod/iPhone and reset them.
After starting up the iPod/
iPhone, connect the product
using a cable.

Disconnecting the iPod

Remove the connector.
When disconnecting the iPod
connector, grasp the connector
firmly and pull it towards you.