Renin Modena 200097 Manual De Instrucciones página 3

MAPPING OUT THE MIRROR BACK
1
PLATE INSTALLATION AREA
A. Lay mirror carefully with mirror facing down flat and remove the
back plate of the LED illuminated mirror (Fig 1A). Be sure to
disconnect the sensor switch wire prior to completely separating
the mirror from the back plate. Separate the back plate from the
mirror (Fig.1B).
B. Place the back plate over the area where the illuminated mirror
will be installed and draw in the holes. Ensure the unit is level
before marking your holes (Fig.2).
Fig.1A
Models: 200097, 200158, 200169,
200170, 200156, 200157
Model: 200155
Fig.2
Mark installation holes
Use level
INSTRUCTION MANUAL | HARDWIRED LED ILLUMINATED MIRROR | ENGLISH | 3
Fig.1B
Disconnect
Separate the back plate from the mirror
PART# 98-3200 REV.B