Proline MC16 Manual De Instrucciones página 4

2. Place the blade attachment onto the pin in the middle of the receptacle.
3. Fill the receptacle with ingredients. Do not exceed the MAX. line.
Make sure the ingredients are chopped or sliced into small pieces before processing.
4. Place the lid onto the receptacle until a click is heard. The chopper will not work unless the lid has been properly
fitted.
5. Place the power unit on the receptacle with lid.
6. Plug the chopper into the mains socket.
7. Press and hold the power button.
Wet or soft ingredients can be processed for short length of time.
Do not run the chopper continuously for more than 1 minute. Allow to cool down for 5 minutes before further
use.
8. Remove the plug from the mains socket.
9. Remove the power unit, the lid and the blade attachment before emptying the receptacle.
10. Attach the sprinkle attachment to the receptacle. Hold down the sprinkle attachment when pouring the processed
ingredients.
Recommendation to process carrot
Wash carrot. Cut into 2cm pieces then soak in water for 30 minutes. Fill the receptacle with carrot pieces making sure
the MAX line is not exceeded. Run the chopper for approximately 1 minute. Always let the chopper cool down to room
temperature after use.
Useful Hints
The appliance is equipped with a safety switch that prevents the chopper from switching on when the lid is not
fitted properly.
The appliance is not designed to chop hard ingredients such as coffee beans, ice cubes or frozen foods.
Always attach the blade attachment before adding the ingredients.
Wet ingredients can easily be liquefied if processed too long.
Uniform results can be achieved by adding same sized pieces of food.
If the ingredients are to be pureed, they must be cooked beforehand.
ATTENTION:
Do not add boiling hot liquids.
Do not overfill the receptacle.
Do not operate the chopper without food in the receptacle.
All manuals and user guides at all-guides.com
EN
3