Kalorik TKG HA 1002 Manual De Instrucciones página 15

Fax +32 2 359 95 50

 Once you have finished the preparation, stop the appliance (position OFF) and unplug
the appliance.
 Remove the jug from the base turning it anticlockwise and lifting it up. Then remove the lid
and pour the liquid into the desired receptacle.
 Caution: your appliance is not designed to mix hot preparations and the glass bowl could
break otherwise. If nevertheless you wish to prepare hot drinks or soups, let the whole cool
down to a temperature lower than about 60°C (tepid preparation) before pouring it into
the glass bowl. In case the lid would come up in spite of the precautions mentioned in
section "Important safeguards", you can also empty part of the preparation and mix it in
several times.
CLEANING
 Always unplug the appliance from the power supply before cleaning it.
 Remove the accessories before washing them in soapy water. Do not use scouring pads
for the plastic materials. Do not place them in the dishwasher.
 The metal part of the beater and dough hook can be removed from the plastic support
for easier cleaning. These metal parts are dishwasher-safe. When reassembling, make sure
that the lugs of the metal part enter into the slots of the plastic part and turn all the way to
the stop.
 Do not clean with any abrasive scouring pad or steel wool, as this will damage the finish.
 For a quick rinsing of the pouring jug (for example between two preparations), you can
use clear water and switch on your appliance for a few seconds. In this case, do not use
any detergent.
 For a full cleaning of the pouring jug, remove it from the motor block. Then you can clean
it with soapy water and rinse thoroughly with clear water. Dry before assembling.
 You can wipe the motor block with a soft damp cloth.
 Remove and clean the sealing ring that can be found in the cover of the blender jug after
each use. Dry it thoroughly and put it back in the lid of the blender bowl before using the
appliance again. Using the blender without the sealing ring could cause leaks.
You can wipe the motor block with a soft damp cloth.

 Do not immerse the motor block in water or any other liquid.
PROTECTION OF THE ENVIRONMENT – DIRECTIVE 2002/96/EC
In order to preserve our environment and protect human health, the waste electrical and
electronic equipment should be disposed of in accordance with specific rules with the
implication of both suppliers and users. For this reason, as indicated by the symbol
rating label or on the packaging, your appliance should not be disposed of as unsorted
municipal waste. The user has the right to bring it to a municipal collection point performing
waste recovery by means of reuse, recycling or use for other applications in accordance with
the directive.
The user manual is by simple request also available in electronic format from the after-sales
service (see warranty card).
All manuals and user guides at all-guides.com
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
15
Assembly page 15/52
on the
TKG HA 1002 - 140312