Operating - EarthWise PW190002 Manual Del Propietário


Securely attach the home garden hose (not supplied)
to the water inlet fitting ( located at bottom of the
unit). Connect the garden hose to water supply. ( Fig.
6)
WARNING: The appliance is INTENDED to be used
at a temperature above 0 degree.
Fig. 6
TO WASH WITH WATER
1. Turn on the water supply tap.
Connect the washer to the power supply and turn the
switch to "ON/I" position. Then press trigger.
NOTE: Before pressing trigger, make sure lock-off switch
is in "unlock" position.
WARNING: Do not start the machine without connecting
and turning on the water supply because it may cause
damage to high pressure seals and reduce the service
life of pump.
2. Release the trigger and turn the switch to "OFF/O"
position. Turn off the water supply tap.
NOTE: When not in use, make sure Lock-off switch is in
"Lock" position.
ASSEMBLY
TO START PRESSURE WASHER ( Fig. 7)

Plug the pressure washer into the power outlet.

Press TEST button, power will be cut and indicator
will be OFF. Do not use if test fails.
We recommend you to press the test button every time
before using pressure washer to ensure the protection
works.

Press the reset button, and the indicator will
illuminate, which means you are ready to use.
NOTE: To maintain good function of GFCI, please
implement it once a month.
Fig. 7
RESET BUTTON
TEST BUTTON

OPERATING

3. Adjust the High/Low pressure nozzle setting to high
pressure, pull the trigger, and high pressure water
flow will come out. You could rotate the High/Low
pressure nozzle collar to change it from a fine point
spray to a wind fan spray. ( Fig. 8 - 10)
Fig. 8
Fig. 9
At same time, you can push sliding button on the gun to
unlock to change fan spray's direction by rotating High/
Low pressure nozzle (A).
Fig. 10
6
PW190002
A