Extremis Abachus Manual página 21

of the tabletop using the 6 M10x55 bolts and
the 6 M10 flat washers. Do not tighten the bolts
completely at this stage.
3. Position the assembly disk in the middle of the
table between the three legs. Make sure that the
tube for fastening the Inumbrina parasol will be
facing downwards once the table is resting on its
legs. Fasten it using the 6 M10x55 bolts. Now also
tighten the bolts mentioned in step 2.
4. Fasten the arms using the M10 spring washer
and the M10x25 bolt. Attention: Make sure that
the sticker in the middle of the arm is facing
downwards once the tablet is resting on its legs.
5. Turn the table around and place the cover disc
with tube in the middle of the tabletop.
Small ashtray - p11
1. a. Loosen the rotary knob underneath the
tabletop.
b. Remove the cover tube.
2. Insert the ashtray under the tabletop in the
appropriate opening.
3. a. Insert the cover tube in the middle of the
tabletop.
b. Lock it into place by turning the knob
clockwise.
Big ashtray - p12
1. a. Loosen the rotary knob underneath the
tabletop.
b. Remove the cover tube.
2. a. Insert the three big ashtray tubes in the
provided openings of the assembly disk.
b. Give a quarter turn so that they can not fall out.
3. a. Insert the cover tube in the middle of the
tabletop.
b. Lock it into place by turning the knob
clockwise.
Floor fastening - p14
1. Place the floor fastening plate between the table
leg groove on the inside of the table leg.
2. Mark the places on the floor where the floor
fastening is to be located.
3. Remove the floor fastening plate and now drill at
the places marked.
4. Now place the floor fastening plate back between
the table leg groove and attach using bolts or
screws suitable for the type of ground on which
the Abachus is to stand.
With Inumbrina ø250 - p16
1. a. Loosen the rotary knob underneath the
tabletop.
b. Remove the cover tube.
2. Insert the Inumbrina into the table.
3. Lock it by tightening the adjuster screw
clockwise. The Inumbrina is only properly locked
into place if it can no longer spin on its axis.
4. a. To open the parasol, pull hard on the rope until
the crown meets the bolt.
b. To close it again, hold the rope at an angle as
you release it. TIP: continue to hold the rope at
an angle until the parasol is completely closed.
The parasol should always be fully opened or
completely closed.
5. Now insert the rope into the provided hole in the
parasol tube.
MAINTENANCE
Wood
DAY TO DAY CLEANING
Clean regularly and after every use
Wood doesn't need much maintenance, but the
better you treat it, the longer it will last. Cleaning
the wood regularly and immediately after use with
a damp cloth will prevent fluids from penetrating
deep into the wood. An oiled table will absorb liquids
less quickly, keeping it clean for longer. To remove
stubborn remains of dirt, simply use a stiff brush
and some water. Be careful not to permanently
damage the fibres. For this reason, never ever use a
high-pressure cleaner to clean wood.
CLEANING
Once or twice a year
Depending on the weather conditions, wood needs
a descent polish at least once a year. We would
recommend to do this before Spring and before
Winter, if your furniture is outside the whole year
round. Pick one of those humid, cloudy days, as it
is better for the moisture level in the wood to dry out
slowly after cleaning. For a thorough cleaning, we
can recommend our Extremis Wood Cleaner. This
is a bio-degradable cleansing shampoo for wooden
furniture. The product removes grey discolouration,
green deposits and dirt. Should any cracks appear,
you can simply sand them down by hand using 80
grit sandpaper.
OILING
Once a year
You are free to protect your wood from UV, inclement
weather and stains. Needless to say we strongly
recommend to do this once a year. Extremis Wood
Protector is a 100% natural product based on linseed
oil. It is colourless, but the wood will be darker
after this treatment. 0. Remove all residues of old
applications.
21