Regular Cleaning - Extremis Abachus Manual

MACHINE SANDING
Only every 2 to 4 years
After a few years, there will be little cracks and ma-
ybe some warping in your wood. This is completely
normal, because wood is a natural, living material.
Solid wood has the great benefit that you can sand
away the top layer to make the surface smooth and
flat again. You can do this every two to four years
with a hand-held sander. Do it on a dry day. Use 80-
grit sandpaper for this.
REPLACING A WOODEN PART
Hey! You don't need to be an engineer to understand
our products. And you don't even need to be great
at DIY to replace a part. Do make sure that you can't
repair the damage simply by sanding the slat.
Galvanised steel
DAY TO DAY CLEANING
Regularly and after every use
Clean with lukewarm water and a mild detergent or
Extremis Multi Cleaner.
REPARING DAMAGED PARTS WITH ZINC SPRAY
When damaged
Hot dip galvanisation is the most durable way of
protecting metal against rusting. If the zinc coating
is damaged, the exposed metal can rust. This can
easily be touched up with zinc paint that automati-
cally has the same colour and is readily available in
shops. Zinc spray forms a quick drying, self healing
and flexible coating that helps stop corrosion.
Stainless steel
DAY TO DAY CLEANING
Regularly and after every use
Clean with lukewarm water and a mild detergent or
Extremis Multi Cleaner.

REGULAR CLEANING

When dirty
We advise regular cleaning with Inox Cleaner and
Protector.
22
Watch the maintenance video on
our website:
www.extremis.com/maintenance