Orbegozo EV 3500 Manual De Instrucciones página 22

EV 3500
prior to vacuum sealing.
Make sure there are no food otems with sharp edges that may have punctured the bag. If you find a

puncture hole, seal the item in an entirely new bag.
Make sure no liquids were drawn to the sealing strip area.

Check for loose, worn or cracked Upper and Lower sealing gaskets.

Moisture of foods with high liquid content will prevent the bag from sealing properly. Cut bag open

and wipe top inside of bag and reseal.
Bag will not seal:
Check that there aren't any gaps, folds, wrinkles or holes in pre-sealed edges.

Moisture of foods with high liquid content will prevent the bag from sealing properly. Cut bag open

and wipe top inside of bag and reseal.
Thick bag will not seal properly, Press the "seal time + " button to increase the seal time so as to seal

thicker bags
Make sure you've placed the bag in the proper place. When making a bag from a roll, make sure end of

cut piece is on the sealing strip.
 DO NOT attempt to repair or adjust any electrical or mechanical
functions of this unit.
 If you have any questions or comments regarding the operation
of the unit or believe that repair is necessary, please contact our
after-sales department.
Disposal of old electrical appliances.
The European directive 2012/19/UE on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the environment. The
crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you dispose of
the appliance, it must be separately collected.
Consumers should contact their local authority or retailer for information concerning the correct disposal of
their old appliance.
DECLARATION OF CONFORMITY: This device complies with the requirements of the Low Voltage
Directive 2014/35/EU and the requirements of the EMC directive 2014/30/EU.
22