Wiring Requirements - Tripp-Lite NPOEI-60W-1G Guia De Inicio Rapido

Grounding the PoE Injector
Note: These PoE injectors are intended to be mounted to a well-
grounded mounting surface, such as a metal panel.
Grounding and wire routing help limit the effects of line noise
due to electromagnetic interferences (EMI). Run the ground
connection from the ground screw to the grounding surface
before connecting.

Wiring Requirements

Note: Safety measures should be taken before connecting the power
cable. Please turn off the power before connecting any modules or wires.
The correct power supply voltage is listed on the product label. Check
the voltage of your power source to make sure you are using the correct
voltage. DO NOT use a voltage greater than what is specified on the
product label. If the current exceeds the maximum rating, the wiring can
overheat and cause serious damage to your equipment.
• Use separate paths to route wiring for power and devices.
If the power wiring and device wiring paths must cross, make
sure the wires are perpendicular at the intersection point.
Note: Do not run signal or communications wiring and power wiring
through the same wire conduit. To avoid interference, wires with
different signal characteristics should be routed separately.
• You can use the type of signal transmitted through a wire to
determine which wires should be kept separate. The rule of
thumb is that wiring that shares similar characteristics can be
bundled together.
• You should separate input wiring from output wiring.
• It is recommended that you label the wiring to all system devices.
-04-051 933E83-Book.indb 5 -04-051 933E83-Book.indb 5
5
10/14/2021 10:33:57 A 10/14/2021 10:33:57 A